# tunmhub/dsvlab-mcp

Source: https://glimind.com/server/glama%2Ftunmhub%2Fdsvlab-mcp
Registry id: `glama/tunmhub/dsvlab-mcp`
Status: unknown

## Tools (27)

- `apply_input`: 给指定引脚施加 0/1 并传播
- `assert_pins`: 一次性断言多引脚值,返回 pass/fail
- `build_circuit`: 由结构化描述生成合法 txt(带校验),可直接 load_circuit 加载
- `clear_circuit`: 清空画布
- `get_component`: 元件全部引脚(pinName/pinFunction/pinValue)
- `get_component_pins`: 查元件引脚表(画电路必查,引脚号禁止臆测)
- `get_guard_status`: 查防护状态(是否启用/阈值/饿死触发次数)
- `list_component_catalog`: 列出全部 23 种元件:名称/类型/引脚数
- `list_components`: 所有元件概览
- `load_circuit`: 加载电路 txt(默认先校验,有 errors 拒绝加载)
- `power_off`: 关电源
- `power_on`: 开电源
- `press_switch`: 翻转开关(toggle)
- `read_all_pins`: 读所有引脚值
- `read_memory`: 读 RAM6116/EPROM memory
- `read_pin`: 读引脚值(0低 / 1高 / 2高阻)
- `reset`: 复位电源
- `run`: 连续运行:启动 ContinuousPulse 跑 N 毫秒后停(有防护,安全)
- `run_steps`: MCP 主动节拍(推荐):每步触发单脉冲/step 后让出主线程,跑 N 拍,响应最好
- `run_truth_table`: 批量跑真值表(自动遍历 2^n 或自定义 cases)
- `set_pulse_width`: 设置时钟周期(ms,默认 800,测试建议 50)
- `set_switch`: 设置开关到 0/1(处理初值高阻,自动判断是否需要翻转)
- `snapshot`: 全电路所有引脚快照
- `step`: 单步:跑空一次就绪队列(一次稳定传播)
- `stop`: 停止所有连续脉冲(清 timer)
- `trigger_pulse`: 触发单脉冲(须先 power_on)
- `write_memory`: 写 RAM6116/EPROM memory;write 标量按芯片位宽自动拆位数组

Measured by Glimind (https://glimind.com): MCP handshake + tool list only, no tool is ever called. CC BY 4.0.
